UK-POLOS.NET - THE VW Polo Forum

ciclo wrote:sendoc, normally 1.4 petrol (non BlueGT, non GTI) have a 80-pin ECU.
The cruise control pin in the ECU 1.4 is the T80 / 24.
engine code (CGGB) and model year B 1.4 6R.

Hi cilco
6RD 953 503 J - I saw this on aliexpress website.
Will this stalk fit my Polo ?

Thanks for the info ciclo.I'll go ahead and orde the stalk and cable.

sendoc, normally 1.4 petrol (non BlueGT, non GTI) have a 80-pin ECU. The cruise control pin in the ECU 1.4 is the T80 / 24 . It is best to confirm with engine code (there several) and model year (tenth letter of VIN) of your 6R. Thanks again ciclo. The tenth letter is B. It's 2011 model .type 6R1 3...

Thanks for the reply and info ciclo.

My polo BCM is 6R0 937 087 H as seen on VCDS.
Will I be able to retrofit cruise control with this BCM please?

I read that some BCM ending with 087 doesn't have the pind for cruise control.
I don't want to invest in cable, switch , time and money, if it not possible with this BCM.
Thanks

Sorry I couldn't upload the photo. Check this post. http://www.uk-polos.net/viewtopic.php?t=62397 On my switch there is no marking seen.It's the third pin from left on the bottom row. Sensor triggers okay.Response time is about 2-3 secs.To switch off it takes about 5-6 seconds approximately.Suits my...

Would like to hear the outcome of this! If you get it to work please let us know as I might get one myself. Whilst waiting to pick up my son from a party , I just swapped the switch. 2 mins Job. My side lights work as DRL. CH/LH works fine. As alexperkins suggested TFL pin needs to masked. Hope thi...

alexperkins wrote:From what I can tell you need to tape off the TFL pin on the headlight loom that plugs into the kit to get the CH/LH working

Thanks for the quick reply.It's the new model .No red wire in the module.
I haven't masked the TFL pin yet.Is that the pin for disabling DRL?.

alexperkins wrote:I had one of these in my 6R. Worked very well. Literally plug and play
Readily available on ebay UK too - Its the same as the Mk4 golf.

@ alexperkins
Got mine today in post.
How do you setup the coming home/leaving home function?
The chinglish instruction is so confusing.

Finally installed sound proofing foam and then insulation carpet on top.Noise has reduced to a comfortable level now.
Planning to put some more sound proofing material in the boot and doors later.Thanks for all your inputs.

As the title says, has anybody installed this switch seen in aliexpress website?
Please see link below
http://www.aliexpress.com/item/Newest-V ... 27137.html
I am planning to buy this and set up the CH/LH function.

peter_dk25 wrote:6R0863831B
And then you will need 10 of these clips:
1H5863849A01C

Thanks Peter.

Anybody happens to know the part number for the under bonnet insulation for 6R Please?

Thanks for your replies.
i am planning to put some sound proofing layer and get a bonnet insulation and see what happens to the noise level.

What do you people think of under bonnet insulation? What's the purpose?
My 2011 6R doesn't have one.
My old 9N polo had one and the noise level was still high.
Do you think it's worth buying one and installling it?