UK-POLOS.NET - THE VW Polo Forum

I have just bought a '98 VW Polo, three door in dragon green. I've decided to try and update it a little bit.

A visit to the scrappy today found a 6N2 16V in silver, so I took the side repeaters, rear lights and a couple of bits from the inside intending to update and modify the car.

The rear lights fit perfectly, but when I plug in the connector and put the hazards on, two of the other lights top and bottom flash. Looking at the connector and the light, I suspect that I may have to swap over two wires in the connector.

Can anyone clarify exactly what I need to do to make these lights work in my 6N Polo?

Thanks in advance

Red5

Hi Folks,

Someone out there must have done this, any help would be welcome

It's a wire swap of two pins but I can't remember what

Have a search - this has been covered many times

viewtopic.php?f=10&t=9117&hilit=6n2+rear+lights+6n

There you go - proper guide

I used the above guide and it worked perfectly. Took about 30 min.