UK-POLOS.NET - THE VW Polo Forum

Can anyone advise on the best software/reader for looking at fault codes on my 2010 1.2TSI ??

Preferably free software. And which plugs are you guys using ?

Thanks
Wayne

I think my actuator has failed/failing. The car keeps going into limp mode with fault code P0344-B00 (I think, I've lost the damn receipt !!), but it indicated a turbo/actuator problem. Which the car has had in the past.

The car is a 1.2TSI 105 SEL. 2010 plate.

How difficult a job is it to change ...

iichel wrote: Sun Jan 21, 2018 5:43 pm you should be able to just pull off the bearing.

That's what I needed to know. That's great. Thanks for the reply.

Hi guys.

I have a 2010 1.2TSI (105ps - remapped to 130ps)

Do you need any special tools for replacing the rear wheel bearings ? I have just done the fronts, using the correct 5 stud puller tool, but have sold it on and now the local garage reckons my rears also need replacing !!! Typical !

I have ...

Thanks guys.

So they are just dust covers ? I thought they were something to do with the ABS ? But I have to admit, I was just guessing !!!

I have another slight problem now too :oops: I also managed to destroy both speed sensors that are screwed into the top of the knuckle (I am a clutz ! :D ...

Does anyone know if the beige plastic ABS sensor ring that fits at the back of the front bearings on the CV joint can be bought separately ??

I have just replaced the front bearings and the kit came without any and I have managed to destroy one of them :oops:

VW only sell them as part of the hub ...