UK-POLOS.NET - THE VW Polo Forum

I second that RUM4MO , fitting O rings in a tight area can be trying at best it just takes one miss aligned attempt to pinch/ nick them and your cooked. Also unless it’s a massive leak with most A/C machines the vacuum test is useless to pin point a broken o ring type leak.

On the positive side you ...

Here’s a post with all PR codes

https://www.vaglinks.com/Docs/Misc/Audi ... sCodes.pdf

Hi thanks,
Mine does still have the data stickers in the boot and front of the service book,
I’ve had a look through them using OBD11 to decode the numbers and found some referring to suspension components.
PR CODES
1GB : front shock absorption for rough road design
1JB : rear shock absorption for ...

Hi all , just bought a fixer upper , need someone to confirm or deny that the rear shocks on a dune/cross/fun ( wherever you are in the world) are the same as a standard polo of the same era ?
The dune has a raised ride height from factory are the shocks longer or is this all in the springs to ...

I’ve always used camskill for my tyres and have zero complaints with their service and prices.

Anything else is guesswork

As you’re said you have had the evaporator replaced already I believe the expansion valve comes with the genuine unit . Which is inside the heater box behind the dashboard so the dash has been apart/out at least once before. Can you confirm this was replaced ?

Firstly I would get your current battery checked on a decent tester , one which can check the batteries SOC (state of charge) and SOH (state of health) .
You may have charged the battery to 100% SOC but if the battery is in poor condition as you stated the SOH may be down ie no reserve capacity to ...

Old and new hotness
Part number is visible in the picture

How long did lubricating them last , until I could order a new linkage and fit it .as said temporary fix.
As for needing a press absolutely not, the new OEM wiper linkage comes ready assembled all you have to do is remove the motor and swop it onto the new linkage its that straight forward.

Doesn’t the infotainment screen default to the menu screen when the ignition is cycled anyway ?
Someone correct me if I’m wrong .

You need to push the connector into the gateway controller slightly THEN push the tab in and remove the plug .

AI suggests this ,

The G419 sensor is known as "Combi sensor for acceleration and yaw rate For vehicles with electronic stabilisation program -ESP- " and is VW part number 6Q0 907 637 A, the current retail price is £1044 inc. VAT It is located "next to left seat cross member in floor panel" .

More ...

ETKA online is the workshop manual, I believe you buy time to view.

Will it fire up if you use something like easy start ? Have you checked the compression ?