UK-POLOS.NET - THE VW Polo Forum

obd pin 16, cluster pin 31, 32 -> +12V
obd pin 5, cluster pin 16 -> gnd
obd pin 6 -> cluster pin 28
obd pin 14 -> cluster pin 29

In the end I was able to solve all the adaption issues with a massive multiple eeprom comparing from various models and versions. There are big changes in 1xxx eeprom layout, that was long and tedious. Brake fluid ok, speed signal ok, boot lid ok, fuel tank ok, low fuel warning ok, picture ok ...

Yes, for now there is no new or different parts, I just want to start with BCM, for future I have planned to install RLS mirror with auto lights switch, 6c led headlights and a discover media nav.
So in this case can I just disconnect the old one and connect the new one without wiring mods or I ...

Too late.. Already bought. Thank you iichel for your reply. Somewhere I've read one can still learn remotes with a working key, it's correct? I also have online odis.
And about the wirings could you tell me something?

I've just ordered an 7E0937090D for swapping my 6R0937087P, for future retrofits of various things. Read from @iichel there is a need to adapt the wirings and remove the can gw. I think my car doesn't have a separate can gateway, it's possible? It's a MY2014 6r 1.6tdi highline with MFSW, climatronic ...

Would be better if you tell us exactly what do you want to do with the cluster, for immo programming you need only terminal 15, terminal 30, gnd, can low and can high pins, gateway is not needed, same with vcds for coding and adaptions.

A question to who have the amarok dashboard retrofitted in their car;
I've done swap, everything works correctly but the boot lid open warning doesn't.
If I test it with vcds, in the measurement channel IDE00303-MAS00222 there is there is the right behaviour, but nothing appears in the display.
The ...

Could I suggest to be more patient? Sometime the minimum quantity adapt lasts for over an hour.

blue_ming wrote: Thu Nov 26, 2020 6:33 am Hi, man, is it possible to share your 1009 sw file?

If you mean the eeprom dump I'll could share it, no problems.

Tried on bench with odis e and with FFed immo block in eeprom, with frf says no valid session with VWVIN and VN81X, with odx extracted with BV_DashBoardUDS added in LAYER-REF the flash starts and immediately halted with unknown error, both with VWVIN and VN81X.

With my tools I cannot set immo on that version, only until 07xx.
So my question is always valid

Hi guys, I've got a amarok cluster 2h0920871b for retrofitting in my 6r. It have a 1009 sw and i cannot set immo data on it, so I want to downgrade with 0729 sw. Could someone explain me how to do that with odis e? Thank you