UK-POLOS.NET - THE VW Polo Forum

I have tested both codes with both having the same outcome.
currently have the second coding active.

lights are functional front and rear.

I still have to manually activate and deactivate the high beams using the stalk.

the daytime running lights are not working.
from the link you provided, I ...

firstly I appreciate and thank you for all the help you have given to me and others.
You and the guides you make have been great help.


regarding the confusion over the T17/3 - T10/9. I was up very late when writing the post the T10/7 should have said T10/2. I was referring to the red T10 while you ...

I have now finished the installation and coding.

However;
The dipped beams are constantly on even after ignition and key have been removed. Outside of ch lh time.

The main beams are not activated by the rls

The side lights do not work altogether. Except for ch lh lights

I'm a little confused ...

Thanks for the help so far.

Hopefully on the final stretch just repinning the light swich T17 to the new 10 and 2 connections.

on all the documentation T17/6 is vacant however I seem to have it populated. Do I just remove and isolate it or does it need connecting somewhere?

Also the current T17 ...

Hi

Now that all the parts have arrived I have restarted the bcm upgrade. However, I can not seem to find the correct relay to bridge. the pdfs given seem to have a different relay board configuration than my own.
the 1st 646 relay (in the position where the j331 relay should be) is for the fuel ...

Thanks for helping

I have installed the new can lines. And the windows and IC are now functioning.

I am a little confused with the bcm to fuse loom that is in all the documentation you have provided.
https://cdn.discordapp.com/attachments/522136158621270018/1128652552565702677/Screenshot ...

Thanks for helping

I have installed the new can lines. And the windows and IC are now functioning.

I am a little confused with the bcm to fuse loom that is in all the documentation you have provided.
https://cdn.discordapp.com/attachments/522136158621270018/1128652552565702677/Screenshot ...

Hi,
I am currently upgrading my bcm from 6r0937087P to a 7h0937090B however on doing so the windows no longer work and Instrument cluster not responding to turn signal or headlight activation. I have found documentation on how to fix the issue but it all uses premade looms. I have the experience and ...

flashed it and all working. thanks for the help

This is the module I have. Is it possible to flash it with the correct modules firmware?

here is the autoscan from today.

Friday,26,August,2022,11:11:57:10494
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
VCDS Version: 22.3.1.4 (x64) HEX-NET2 CB: 0.4615.4
Data version: 20220407 DS337.0
www.Ross-Tech.com


VIN: WVWZZZ6RZEU047965 License Plate: ML14OXH
Mileage ...

Hi,

I'm retrofitting an 7N0919475 8k module into my 2014 polo 6r that came stock with an 6R0919475 4k module.

When I activate the 8k with the switxh I get a long beep for about 5 seconds and the the switch just flashes, same if I go into reverse.

I have checked all sensor wiring, switch wiring ...