UK-POLOS.NET - THE VW Polo Forum

i took the switched plus from the seat heating relay (the small black box)

Hi,

My cable set had numbers on the cables.
I have pinned the cables to the multiswitch.
if you have a more specific question - just ask.

br


did you have to make a connector for the cable described as t73/34? where did you plug in the cable described as a36?


T73 / B34 -> "Ausgang Signal ...

Hi,

My cable set had numbers on the cables.
I have pinned the cables to the multiswitch.
if you have a more specific question - just ask.

br

To the resolution:
Kufatec has forgotten a cable (no. 17 multi-switch) in the cable harness.
The seat heating now works

The heating module is "used"
When i pull the plug from the module -> 0V
Or should i wait till the seat mats coming ? :/

I tryed with a 2.2 ohm and 2.4 resistor. (on both sides)
Nothing happend /changed ...
the seat mats have not yet arrived :/


VIN : ---
VAG no. : 6R0937087R
Name : J519 BCM PQ25 H+4
Coding : 1E 7A8829E888610100002008F06E4B9CD80080420F60840000200000000000
SW version : 0424
Slave [1] :6R0959801AJ ...

The light didnt show up :/
I ordered a 2.4 ohm resistor.
I give it a try tomorrow

When I started the engine - there is 11.8v at the plug.
When the engine is running - 12.7v at the plug - the switch does not light.
Did he need the 2.4 ohm resistance from the seat heating to illuminate control leds?

No the engine wasnt running.
The key was on "Ignition" position.

Hi Guys :)

i drive a Seat Ibiza 6J SC 2015
Buyed a 6R0959772A Modul and also buyed the kufatec cable kit.
6J0927137AP as switch - 6R0937087R as bcm
I have wired everything correctly - I have plugged in the fuse.
After that i coded byte 15 bit 4 to 1.
I have about 10v at the plug.
When i press the ...