UK-POLOS.NET - THE VW Polo Forum

Hi

Do you still offer the UNits with CP removed for retrofitting in a 6R?

Cheers

Hi all

Does anyone know how to turn off the parking light diagnostic in the Polo 6R BCM?

There is diagnostic options for all other bulbs, but no parking lights

Anyone managed to do this?

Thanks

CymruPolo wrote: ↑Thu Jan 17, 2019 11:35 pm

golffather wrote: ↑Tue Jan 15, 2019 11:43 pm I have a set of OEM led lights which you can retrofit easy

Headlights?

Yes led headlights from a 6C

I have a set of OEM led lights which you can retrofit easy

@iichel

Did you connect the rear seats to the BCM as well?
Or do they work without any BCM connection?

https://www.yetiownersclub.co.uk/forum/uploads/467/Audi_Self_Study_Programme_485_-_1.2l_TFSI_engine.pdf Page 19 is probably what you need. Make sure the acutator is free in movement CHeck out this thread: https://forums.ross-tech.com/showthread.php?5699-P334B-Polo-1-2-TSI-Assistance-Finding-Root-Cau...

CNK wrote: ↑Wed Nov 21, 2018 1:09 am

golffather wrote: ↑Tue Nov 20, 2018 10:27 pm What does the micro power timer mean?

Micro Timer - 1,5mm
check https://www.a4-freunde.com/showwiki.php ... zu+gehoert

ah ok thanks! thats the pins themselves.
I just need to know what signal is on these lines.

On 2013 onwards Polo 6R's, the dip beam and number plates are always on as part of the DRL system - a cheap fix by VW from factory to comply with EU regulations The power for these comes from the TFL and the B terminal of the headlight switch To disable this, you need to isolate or remove the pins f...

In many countries, auto-leveling of high-brightness lights over 2000 lumens is obligatory. Personally I think it is a very good thing to do too. Bright Xenon and LED headlights, when not adjusted and regulated properly, can be very annoying. Be aware, that this is only for the OEM Xenon and OEM LED...

Just to close this thread, there is a pin in the headlight switch (B) which needs isolating.
All good now.

Hi Does anyone have the pinouts for the BCM for a Polo 6R? 6r0937087P BCM PQ25 ELSAWIN is not correct and only lists for system with a stop/start system The current side light voltage is around 11.7v even with engine on and its not able to drive led headlights properly Need to use a relay I think to...

Just checked wiring diagrams and number plate lights connect directly to J519 via T73b/7

But that pin should be empty as per elsawin...

Actually i do have OEM LED units fitted, but that shouldnt make a difference, there should be no power going to them at all when the headlight switch is 0 !

its a standard UK polo mate.

Yes they are on all the time with ignition on, regardless of the headlight switch position.
Are they hard wired in to be ON like the front dipped beam on the 2014 onwards polos?