Retrofit automatic ligths
Posted: Thu Dec 19, 2019 7:34 am
Hi all,
I'm new at this forum. I own a Seat Ibiza 6j, 1.9 TDI from 2009. I'm from Barcelona (Spain) and I hope to do my best at this forum and to contribute with my humble experience.
The car came with automatic windshield cleaning and, as far as I was able to investigate, the sensor is also valid for automatic light. However, it does not have automatic lights and I am trying to install and configure it. Below I indicate the references of the most relevant pieces:
- Sensor installed (RLS): 1k0955559AH
- Control unit: BCM PQ25 - 6R0937087B
- Light control (with auto function): 6J1941531AF
When I enter in the module with Vag-com I see that there are options to activate or deactivate the automatic lights, therefore, I suppose that the BCM supports the functionality (correct me if I am wrong). However, when I turn on the light control, I see that it is not working properly (in position 0 the fog lights on the control light up and when changing position it changes to others). At this point I am blocked, since I do not know why the malfunction is due. I thought it might be that I need to wire from the BCM to the light control, however, I'm going blindly. Has anyone encountered anything similar?
Thanks and best regards!
I'm new at this forum. I own a Seat Ibiza 6j, 1.9 TDI from 2009. I'm from Barcelona (Spain) and I hope to do my best at this forum and to contribute with my humble experience.
The car came with automatic windshield cleaning and, as far as I was able to investigate, the sensor is also valid for automatic light. However, it does not have automatic lights and I am trying to install and configure it. Below I indicate the references of the most relevant pieces:
- Sensor installed (RLS): 1k0955559AH
- Control unit: BCM PQ25 - 6R0937087B
- Light control (with auto function): 6J1941531AF
When I enter in the module with Vag-com I see that there are options to activate or deactivate the automatic lights, therefore, I suppose that the BCM supports the functionality (correct me if I am wrong). However, when I turn on the light control, I see that it is not working properly (in position 0 the fog lights on the control light up and when changing position it changes to others). At this point I am blocked, since I do not know why the malfunction is due. I thought it might be that I need to wire from the BCM to the light control, however, I'm going blindly. Has anyone encountered anything similar?
Thanks and best regards!