F*ck Sake!!!!!!!

Dee-vub · Post by **Dee-vub** » Thu Mar 08, 2007 9:23 pm

Fuckin pissed off!!

Had football training tonight. Finished up after a tough sesh, into the car and starts reversing! Not looking for some odd fuckin reason, *CRUNCH* i reverse the car into a mates bloody civic! Not a dent on his, but my rear bumper has cracked where the smoothing was done!

Absolutely gutted! Cant believe i done that, i'm usually such a careful driver aswell!

Well thats a couple of plans out the window, as this is going to have to go into get repaired!:evil:

Heres the damage!

GRRRR, gonna need refilled and resprayed!

h4r1s · Post by **h4r1s** » Thu Mar 08, 2007 9:44 pm

Stupid Civic!

how bad is it? can the bumper be repaired or will you need a new one? feel sorry for you mate

such a nice car as well

Dee-vub · Post by **Dee-vub** » Thu Mar 08, 2007 9:51 pm

h4r1s wrote:Stupid Civic! how bad is it? can the bumper be repaired or will you need a new one? feel sorry for you mate such a nice car as well

Its about a 6-8" crack, It is repairable, but just a f*****g nuisance mate! and i am so unbelievably skint! The cash was gonna be goin towards some tasty mods, but thats them defo on hold now!

Its my fault for not looking, but he was parked in such a daft place!

DanDiesel · Post by **DanDiesel** » Fri Mar 09, 2007 8:54 am

ah bugger mate, feel for ya! hope ya get it sorted soon!

vdubit · Post by **vdubit** » Fri Mar 09, 2007 6:43 pm

You Pilluck!

Here's what i'd do:

Go to your local factors and buy a tin of Upol Plasx 6 plastic filler. Its around Â£12. Dig the hole out a bit using a screwdriver. Apply filler and sand. Start with 60grit sandpaper, then 240 the 400. Refill any dimples and sand until perfectly smooth, finishing with 600 grit wet. Prime with an aerosol (just the repair and an inch of surrounding area. Flat with 800 grit sandpaper. Prime and sand again. Buy an aerosol in the correct colour from halfords or similar. Spray to the area, again with another overlap of around an inch. Build up several thin coats until its nicely covered. Flat back the paint using 1500 grit paper. G3 (or lots of t-cut) then polish up with good quality polish.

Total cost of repair? Under Â£20 and a sunday morning.

Go on, give it a go, its that easy!

Dee-vub · Post by **Dee-vub** » Fri Mar 09, 2007 7:28 pm

I really would f**k something like this up. Will the colour match??

vdubit · Post by **vdubit** » Fri Mar 09, 2007 7:40 pm

Halfords is surprisingly the best match aerosol i've ever found!

Give it a go, if u f*ck it up, its only Â£20 down the drain

dubpilot · Post by **dubpilot** » Fri Mar 09, 2007 9:00 pm

^^for what its worth, you got me completely sold on the idea! couldnt have put it better myself.

Post by **alexperkins** » Fri Mar 09, 2007 9:29 pm

I totally agree -its a great idea. What polish would you recommend using (as mine is the same colour and theres a few bits i need to sort out

)?

Cheers,

Alex

toXXin · Post by **toXXin** » Fri Mar 09, 2007 10:53 pm

vdubit has a very valid point. If you do screw it up, you've lost Â£20 at most.

My advice would be:
* Put the aerosol in a bucket with some nice warm water while you get ready as this makes the paint easier to mix and spray.
* Shake the can for at least 2 minutes
* Spray from a distance and do it in single layers. Patience is a virtue! Seriously, take your time and it'll be fine!
* Don't spray all your other panels at the same time

Mask up

Dee-vub · Post by **Dee-vub** » Sun Mar 11, 2007 1:31 pm

I'm just gonna buy a new bumper and use this shagged one as a bit of practice. Gonna learn the tricks of the trade for the future

dino · Post by **dino** » Mon Mar 12, 2007 9:40 pm

Gutted Phil, hope it gets sorted