Anyone whos put a better spec interior in a L spec

[Robi mk4]

rite well i had a L spec interior where the rear seats are one piece and im putting a 16v interior in, now coz its got the 60/40 split rear seats i cant fit the back parts, the bits you sit on the holdings for a 60/40 split were already there so i put that in easy, but the bit u lean against there is nothing to hold them in the middle! how have people got round this? Thanks

[SpikeyG40]

think you may have posted in the wrong forum buddy! will move it to the mk4 section!

[pip_polo]

good point, i need new interior and was thinking of that.
help would be good here lol

[LeMeph]

If i understand what you are saying then there should be a clip, like a U shape.

They should fit identically the same as your previous interior!!!

Unless you got a 6N2 interior, then i dunnoo.

[1litreheater]

This is the problem i came across and previously posted it here and at clubpolo and no answer. So i fiddled around and worked it out.

Get a flat head screw driver and at one end of the bit you lean it against slide it in and lift it up. It doesnt look like it will work but i asure you after ten minutes fiddling around and finding the right gap ull get it.

Il post an example up if you cant find it.

Hope this helps

[Robi mk4]

in the middle of the part u lean back againt u need 2 of the clips that are either side, so i can attach the bottom right n left as they fit into the old housings, but in the middle you need a further 2 holdings for the split. does this make sense or do i need pics?

[monkeyalan]

I think I see what you mean.

with no split the seat back only needs support at either end at the bottom.

with a 60/40 split seat back there an extra bracket to suport the two halves in the middle.

like this.

[Robi mk4]

yeah thats what im missing can i simply pull a catch out of a better spec polo?