Anyone got a fix for fitting 15mm hubcentric spacers to the rear?
Fronts fit no problem but because the rear hub Center sticks out so much it won’t allow the spacers to sit flush!
Rear spacer issue 15mm
Rear spacer issue 15mm
- Attachments
-
- 1799BD1A-D56B-42B8-8EB0-0552CF01ECC8.jpeg (2.27 MiB) Viewed 582 times
-
- Polo 6R rear spacer
- 0E213279-F3CB-4F51-B9FE-29BD98485063.jpeg (2.16 MiB) Viewed 582 times
-
- Platinum Member
- Posts: 1104
- Joined: Thu Feb 06, 2020 7:57 am
- Drives: Polo 6R 2010 1.6 TDI
- Location: budget build
Re: Rear spacer issue 15mm
center bore to small? measure it. did you clean the hub surface from rust?
Re: Rear spacer issue 15mm
Center Bore is Standard VW 57.1, it’s just too deep!
-
- Platinum Member
- Posts: 1104
- Joined: Thu Feb 06, 2020 7:57 am
- Drives: Polo 6R 2010 1.6 TDI
- Location: budget build
Re: Rear spacer issue 15mm
Get them machined then, to make it deeper. Add additional +0.5 mm to the difference.
You can grind down the hub lip but this is a hack way, cheaper but I wouldnt do it personally.
You can grind down the hub lip but this is a hack way, cheaper but I wouldnt do it personally.
Re: Rear spacer issue 15mm
Have you managed to resolve this?
I also tried to fit some Bimecc 15mm spacers to the Rear on Saturday and I can't get them flush either! Fronts were fine.
It's the internal chamfer highlighted in Red which is stopping it.
I also tried to fit some Bimecc 15mm spacers to the Rear on Saturday and I can't get them flush either! Fronts were fine.
It's the internal chamfer highlighted in Red which is stopping it.
- Attachments
-
- 3.jpg (231.01 KiB) Viewed 474 times
-
- 2.jpg (143.56 KiB) Viewed 474 times
Re: Rear spacer issue 15mm
I’ve ended up purchasing more spacers, a pair of 10mm without the hubcentric locating lip, and a pair of 5mm the same. They are still 57.1 Center bore size. Not got round to fitting them yet.
Hopefully either I can use both those to make 15mm and there is still enough space on the hub to centralise the wheel or I may add the 5mm to the back of the 15mm!
Hopefully either I can use both those to make 15mm and there is still enough space on the hub to centralise the wheel or I may add the 5mm to the back of the 15mm!