Page 2 of 3
Posted: Wed Jan 02, 2008 7:48 pm
by Tim_GTi
looking good neil

, but just how how much extra weigh does that add? is it heavier than the back bench?
Posted: Wed Jan 02, 2008 11:06 pm
by adam_0612
how did u stick the carpet down, with glue and staples???
also where did u buy it from? will a local halfords sell it?
Posted: Thu Jan 03, 2008 6:59 pm
by Tim_GTi
adam_0612 wrote:how did u stick the carpet down, with glue and staples???
also where did u buy it from? will a local halfords sell it?
Have you checked eBay? i'm sure they'll do it on there
Posted: Thu Jan 03, 2008 8:25 pm
by kipper
the carpet i believe u can get from most car shops as in halfords c.a.r etc. they should do they spray adhesive to. or u can normally get carpet spray adhesive from most if not all diy stores. u can always then use blue tacks (small nails with slightly bigger heads) not clout nails, and use them to nail the left over material on the underneath the board. thats how i do and it works great
Posted: Tue Jan 08, 2008 4:37 pm
by Dee-vub
Looks decent buddy! Nice little subtle set up! Perfect for the polo
I'm just about to start my build

Posted: Tue Jan 08, 2008 5:54 pm
by Bepe
nicer phil, some top gear there mate, keep us posted
the carpet was from halfrauds and so was the spray adhevsive

carpet was £25! for 2mx1m and the spray was about £5
Posted: Tue Jan 08, 2008 6:45 pm
by Tim_GTi
Dee-vub wrote:

haha this pic freaked me right out!!
i thought your sub was a mid range,
the mid-ranges tweeters
and your amp a crossover
then saw your headunit and thought hang about since when did they make them that small?!!!
nice pile of gear

Posted: Tue Jan 08, 2008 8:08 pm
by h4r1s
nice bit of kit that

i want that RE sub

Posted: Tue Jan 08, 2008 11:25 pm
by ModifiedMadness
h4r1s wrote:nice bit of kit that

i want that RE sub

Don't fancy this one then?

Posted: Tue Jan 08, 2008 11:29 pm
by Bepe
nice install that but not keen on how the cables are
Posted: Wed Jan 09, 2008 12:56 pm
by h4r1s
ooo is that the mxd1 ain't it? 1600wrms

i would but i need my boot space

been looking at the SE12v4 i think it is, but there's something going on with REaudio, they are supposedly not distributing anymore or something like that.
Posted: Wed Jan 09, 2008 6:39 pm
by Tim_GTi
you selling it Tom?
Posted: Wed Jan 09, 2008 7:15 pm
by ModifiedMadness
h4r1s wrote:ooo is that the mxd1 ain't it? 1600wrms

i would but i need my boot space

been looking at the SE12v4 i think it is, but there's something going on with REaudio, they are supposedly not distributing anymore or something like that.
I've got the MX12 D2 wired to 1ohm and getting 1500w RMS which is what it's rated at. I'd love to give it 2000 RMS though
RE are still distributing, they're sold through Car Audio Direct or you can go through Blade Ice who are the European Distributors of RE Audio, you can get them on 01908 610441.
Tim_GTi wrote:you selling it Tom?
No chance

Posted: Sat Jan 12, 2008 9:03 pm
by Dee-vub
Yeh tom i defintely did want that one, but i just couldnt stretch my budget that far i'm afraid

This one should do the job, i'm not after a competition install......Just a better than average install, which i know this will be.....just need to get the wiring kit and deadening and it will be cracked on with

Posted: Sun Jan 13, 2008 4:16 pm
by ModifiedMadness
Is it the SE you've got Phil? I had the newer version and that did the job nicely off 450w RMS.
I'd love to give mine more really, think I'll need a better battery at some point too!