Page 2 of 2
Posted: Mon Apr 28, 2008 8:04 am
by shanethb
Posted: Mon Apr 28, 2008 11:07 am
by KennyPOLO_Gti
kc wrote:lol
that pikey mid is full on pikey lol
i had pikey mod (another version) on my first gti
but intead of drilling holes like he has and i drilled loads of little holes and didnt nother with that metal air panelling thingy ma jig...
but as andy says... check the ibiza.... im sure it will fit with a little bit of cutting...
Drilling wee holes would look the best i think. Dont think u would notice it. Did u feel a difference????
Posted: Mon Apr 28, 2008 11:08 am
by Tim_GTi
Yeh that's a little better
Posted: Mon Apr 28, 2008 11:09 am
by Tim_GTi
what about mesh stuck to the inside of it?
Posted: Tue Apr 29, 2008 12:19 am
by Jeff GTi
rather than cut out a big section with a blade and insert in a vent, im simply going to mask off the area behind the cooler in a square, and with the dremel, cut through the plastic in roughly 10 diagonal straight lines
thus allowing the heated air to escape, yet not being big enough to allow medium to largedebris and stones etc entry to the inside of the bumper
should also look very neat too, and more oem