UK-POLOS.NET - THE VW Polo Forum

zedzo wrote:is that air filter on the turbo like a dose pipe

dose pipe dont get u bud

looks mint !!

whitegtipolo wrote:looks mint !!

thanks chirs

Some videos of this beast when shes up and running i hope???

of corse will be going down when it hits the dyno

dose pipe

https://www.youtube*.com/watch?v=b5YboYGt5U0

zedzo wrote:dose pipe

https://www.youtube*.com/watch?v=b5YboYGt5U0

i get you now

update most of the work for a late has been on heat management




also some pics of how close the manifold and exhaust are and cat back system from a member its going to good use

Ha, that is insainly close dude!

Having all that close is gona be super hot isnt it?

Have u looked into poly exhaust mounts? Stop's the exhaust from moving around so much, especially as u have little room for movement???

What you using to keep the heat down?

Trottagti wrote:Ha, that is insainly close dude!

Having all that close is gona be super hot isnt it?

Have u looked into poly exhaust mounts? Stop's the exhaust from moving around so much, especially as u have little room for movement???

What you using to keep the heat down?

its very close movement is caused buy the engine mounts this is why ive replaced them all will do the exhaust rubbers if needed will see how it goes for now

for the heat http://www.zircotec.com/page/-_performance_white/41

Can you please show me a photo of the exhaust just over the rear axle? Is your exhaust 3" all the way? Where will you get the inlet pipe and the charge pipe from? And please tell me where you bought the engine mounts from I'm just putting my engine back into the polo, with a gt2871 Thanks!

vlad_pvs wrote:Can you please show me a photo of the exhaust just over the rear axle? Is your exhaust 3" all the way? And please tell me where you bought the engine mounts from I'm just putting my engine back into the polo, with a gt2871, and I only need the exhaust and engine mounts. Thanks!

dont have a photo at the min of the exhaust over the rear axle but i can tell you its a full 3" all the way

exhaust from
http://www.blueflameperformance.com/
custom mounts from
http://www.vibra-technics.co.uk/
cambelt side mount is off the shelf
there is a wait time on the gearbox mount as you have to send yours for it to be modded

Thanks for the quick reply! How about the inlet pipe and the charge pipe? will you custom make those? I can't wait to see a vid with your Polo

vlad_pvs wrote:Thanks for the quick reply! How about the inlet pipe and the charge pipe? will you custom make those? I can't wait to see a vid with your Polo

ya they are custom made got some pictures they are a few pages back

good luck with the GT28

few more pics