just so you know (suspension)
Posted: Tue Jul 01, 2003 7:22 pm
if you brouse some magasines you will prolly notice that no one sells any suspension that lowers the mk5 more than 80mm (although some are capeable) here is the list of things that might be concidered bad when you go to -11 centimeters :
Note; this is with 195 45 15`s because with 195 50 15 tyres you will start rubbing at -60 roughly
bottom arm rear bush ripped (solution replace bush/arm)
drive shaft hits chassis leg
anti roll bar hits chassis leg
drive shaft hits the rear of the sump causing the wireing loom to get ripped up and breaks its support causing it to got against the crank pully
you cant use the omp shid plate because it just sits on the floor
if you have a front lower strut brace it will not thank you
if you dont have a front lower strut brace then the sump wont thank you
you will actually bottom out on those rubber speed bumps at maccy d`s
if you have a large exaust below the rear bumper then it will touch the floor under hard cornering
however
i was running 7x 15 wheels on i think a 28 mm offset and my arches are only modifed by the rubbing when i was running 50 profile lol :LOL: but even at -11cm i bibnt rub at all unless i was really being silly
for reference i am using KW variante 2 coilovers and even though i was running them at nearly full hard i used to get a lot of compliments about how comfy the ride was even from people who dont like modified cars
Note; this is with 195 45 15`s because with 195 50 15 tyres you will start rubbing at -60 roughly
bottom arm rear bush ripped (solution replace bush/arm)
drive shaft hits chassis leg
anti roll bar hits chassis leg
drive shaft hits the rear of the sump causing the wireing loom to get ripped up and breaks its support causing it to got against the crank pully
you cant use the omp shid plate because it just sits on the floor
if you have a front lower strut brace it will not thank you
if you dont have a front lower strut brace then the sump wont thank you
you will actually bottom out on those rubber speed bumps at maccy d`s
if you have a large exaust below the rear bumper then it will touch the floor under hard cornering
however
i was running 7x 15 wheels on i think a 28 mm offset and my arches are only modifed by the rubbing when i was running 50 profile lol :LOL: but even at -11cm i bibnt rub at all unless i was really being silly
for reference i am using KW variante 2 coilovers and even though i was running them at nearly full hard i used to get a lot of compliments about how comfy the ride was even from people who dont like modified cars





