Page 1 of 1
K&N Induction Kit VS K&N Panel Filter
Posted: Wed Jun 01, 2005 4:06 pm
by PhilGTi
Which is better out of these two? Can't say i know anything about them. Im more interested in performance/smoothness of the results over how loud it makes the car.
Can anyone explain what both will do? How much are each of them. Its for a 2001 6N2 Polo 1.4 8V.
Cheers, Phill.
Posted: Wed Jun 01, 2005 10:09 pm
by mikegti
I'm no expert, but I believe that the cone filter would be best, as long as it has a good cold air feed and maybe a heat shield (depending on where you mount it in the engine bay)
Of course, the panel filter will be a lot cheaper and easier to fit!
Try doing a search, I think people have discussed this topic a few times.
Posted: Thu Jun 02, 2005 12:35 am
by PhilGTi
Ordered the K&N Induction kit today, only £55.99 so who gives a s**t if its not all that good? Also ordered some sound deadening for the engine bay, sounds silly i know but it will reduce all the rattles and road noise and leave the exhaust/induction note.
Phill.
Posted: Thu Jun 02, 2005 12:37 am
by carmadaaron
kit will sound better than the panel....
£56 sounds good man
where from?
Posted: Thu Jun 02, 2005 12:39 am
by PhilGTi
Aaron come on msn you slag!
Phill.
induction kit
Posted: Fri Jun 03, 2005 9:53 am
by jon_poloV
are you sure thats the new one they made for the 1.4 8v
57-0554
comes with all corret tubes etc to link in the breather etc, i had this one after my bmc kit and it was good.
jon