Page 1 of 1
need a bit of help. i'm in a spot of bother lol
Posted: Fri Jan 13, 2006 1:00 pm
by rishisisodia
there's a few things i wanna knw.
1st) is how 2 take the glovebox out.
2nd) how 2 do the wiring for components if i am amping them.
any help will be most usefull thanks guys n galls x
Posted: Fri Jan 13, 2006 2:57 pm
by Bran
Posted: Fri Jan 13, 2006 5:14 pm
by rishisisodia
lol thanks m8. erm the bit i was after was how 2 get the wires in2 the door x
Posted: Fri Jan 13, 2006 5:54 pm
by david burton
Drill holes
that's what I did, I drilled a small hole in the A pillar below the main wiring plug, then zip tied the wires to the rubber tube running to the door and then cut a small hole in the rubber tube where it enters the door.
You could (possibly) drill out a part of the big connector plug thing and feed the wires through there. Depends if you have any space free in the connector block.
The connector will twist off - you'll need some big grips to take it off tho!
Posted: Fri Jan 13, 2006 5:56 pm
by Bran
Posted: Fri Jan 13, 2006 10:35 pm
by rishisisodia
awww wicked. u guys are gangsta's! lol thnks ever so much. after my exams i'l do it all n take pix n show u. thanx again
rishi