Page 1 of 1
Mounting Plate Holders
Posted: Wed May 17, 2006 4:12 pm
by mk5_sdi
My german plates just arrived, just wondering how to fix the holders to my car, is velcro a possibility, dont really want to drill a hole in my bumber, and it allows for a quick change if the cops stop me, use the old show excuse

, im hoping ill get away with them here in northern ireland cause we only have 3 gatsos in the whole country!!!!

and this seems the main reason for outlawing them.
Posted: Wed May 17, 2006 4:25 pm
by ModifiedMadness
Sticky Numberplate pads.
Posted: Wed May 17, 2006 4:29 pm
by mk5_sdi
are they not just those 3m things that are a pain to rip off and change?
Posted: Wed May 17, 2006 4:36 pm
by ModifiedMadness
Yes, but with velcro dont forget there's more of a risk of it falling off.
The pads aren't really too bad with some tar remover.
Posted: Wed May 17, 2006 4:39 pm
by mk5_sdi
its just if i do get stopped i want something which will allow me to put on my "legal" plates quickly and easily.
and change em back to my german one easily if i wish.
Posted: Wed May 17, 2006 4:42 pm
by ModifiedMadness
You'll only get stopped so many times I should think before they properly do you for them.
Posted: Wed May 17, 2006 4:50 pm
by mk5_sdi
Its just i thought it would be more likely to get away without a fine if i could change em then and there, was going to get a set of legal plates to keep in the boot. Pads would be kinda alkward to change roadside.
Posted: Wed May 17, 2006 5:02 pm
by Redline
Can you not take the plates out of the holder?
As if you can, would it not be easier to fix the holder on firmly and just swap the plates into and out of it?
Posted: Wed May 17, 2006 5:07 pm
by mk5_sdi
don't think british plates fit butt ill check, if they do man i sound stupid lol, suppose i could trim em down to fit if needed.
Posted: Wed May 17, 2006 7:32 pm
by ModifiedMadness
Not too sure, but if not just get a set of plates made to fit
