Page 1 of 1
Where to get BMC CDA
Posted: Thu Jun 29, 2006 9:12 am
by loud
does anyone know where the cheapest place to get a BMC CDA for a 100bhp valver is?
Posted: Thu Jun 29, 2006 10:49 am
by neilw
Try 2modified through club polo. Neil
Posted: Thu Jun 29, 2006 1:18 pm
by Petrified
Posted: Thu Jun 29, 2006 2:04 pm
by loud
interesting...
will it have the right fitments for the cold air feed though, the 16v polo requires a join that the 8v polo doesnt, dont have a clue about the lupos though
Posted: Thu Jun 29, 2006 3:48 pm
by Petrified
I beleive you make your own cold air feed. the bmc comes with a flexible pipe around 3' long which should fit on to your existing air feed, but to get the most out of it I would remove the existing one and make your own. as far as I know the polo and lupo are very similar. at least mine were! and take the cold air feed from the driver side wing. it's not that great imo.
Posted: Thu Jun 29, 2006 4:41 pm
by loud
the bmc comes with aluminium ducting to be used for the cold air feed
Posted: Thu Jun 29, 2006 4:44 pm
by loud
i asked 2modified why the 16v ones are more expensive than the 8v, this is the reason...
The basic kit is around £140 which comes with the box and a cold air pipe
the Polo 16v also comes with a Silicone bend to attach to the Inlet and a breather filter