Page 1 of 1

Hand brake problem?

Posted: Sat Sep 23, 2006 1:13 pm
by mmh
The other day I got into my car and tried to reverse to get out of my parking spot, I put the handbrake down fully and put it in reverse but the car didn't move and it felt like the rear nearside was raising up.

I went out and checked if anything was in the way but there was nothing.

Got back in tried again and same thing, so I tried moving forward - there was a little pop and then it moved forward and then I could reverse again.

Today I pulled the hand brake up and it would not engage after a couple of goes it did in the end.

What might this problem be any ideas?

Cheers,
Mo

Posted: Sat Sep 23, 2006 2:14 pm
by ModifiedMadness
It happens with mine sometimes after leaving it sitting overnight, it just sticks. Pulling forward sorts it out though.

Posted: Sat Sep 23, 2006 11:09 pm
by dino
just where the moisture overnight causes the pads and discs or drums to produce surface rust. happens to mine the morning after i wash her too. jsut pops off and then after a little dab on the brakes its clear

Posted: Tue Sep 26, 2006 6:22 pm
by jonnopolo
Mine used to stick too (just one side) if left for a couple of days or more. I now leave it in the garage with the handbrake off.

Posted: Tue Sep 26, 2006 9:34 pm
by Polo Paul
If the handbrakes not going on again after its popped off though, there is a problem, could be a snapped handbrake cable