cleaned the ibiza up a bit (its not often :-o)
Posted: Sun Oct 15, 2006 11:03 pm
well last friday, i decided that it was finally time to fit my new plate surrounds, and while the plates were off the car, i gave the bodywork a good wash and a clean and also cleaned inside and tidied up the engine bay!
used Quantam car shampoo (VAG own) to wash the outside
then used Turtle Wax 'Wax It Wet' to shine the paintwork (good stuff for cheats lol)
used a dry chamois to just rub over the car to get any fluff or drops of water off and to wipe the windows down
then used Megs 'back to black' trim renovator stuff on the side strips, lower front and rear splitters, grills and wipers
then gave the wheels a quick going over with a sponge and car shampoo again
(they had a GOOD clean last week so wasn't much to do)
and thats about it, not up2 Dino's standard, and on the evidence, Josh's either, but i'm pleased with my results!
here are some quick snaps (please excuse the little black dots in the pics, they are on the cam lense!!)




and a shot of the car with my new plate surrounds and show plates on!!

and the obligatory arty shot

hope u like my few hours work (think it was about 5 hrs in the end)
the car has now been rite royally shat on (after just 2 days.....so annoying) and the front plate fell off (it was only stuck on with number plate stickers....temp measure) and is now on my dash and the rear one could go the same way!!
ah well, at least the pics came out ok!!
opinions please
used Quantam car shampoo (VAG own) to wash the outside
then used Turtle Wax 'Wax It Wet' to shine the paintwork (good stuff for cheats lol)
used a dry chamois to just rub over the car to get any fluff or drops of water off and to wipe the windows down
then used Megs 'back to black' trim renovator stuff on the side strips, lower front and rear splitters, grills and wipers
then gave the wheels a quick going over with a sponge and car shampoo again
and thats about it, not up2 Dino's standard, and on the evidence, Josh's either, but i'm pleased with my results!
here are some quick snaps (please excuse the little black dots in the pics, they are on the cam lense!!)




and a shot of the car with my new plate surrounds and show plates on!!

and the obligatory arty shot

hope u like my few hours work (think it was about 5 hrs in the end)
the car has now been rite royally shat on (after just 2 days.....so annoying) and the front plate fell off (it was only stuck on with number plate stickers....temp measure) and is now on my dash and the rear one could go the same way!!
ah well, at least the pics came out ok!!
opinions please