Page 1 of 1
a hole in engine bay for my power cable????
Posted: Thu Feb 15, 2007 12:39 pm
by doublefifteensmk4
i have had a brief look in the engnie bay for a grommet or some type of hole for my 4 gauge power cable.....any1 got any ideas contact me please, i need my bass back
Posted: Thu Feb 15, 2007 1:38 pm
by quality name
theres a post bout it in either the diy section or ice section wit piccys, but i used one of the rubber bungs i juz pushed a screw driver throu then fed the cable through i had to reach behind the passenger side dash to get it but it does the job
Posted: Thu Feb 15, 2007 7:52 pm
by daz1245
hi i found a gromit on the drivers side on the engine bay and i fed my power cable through there i cudnt find another
Posted: Thu Feb 15, 2007 9:49 pm
by bobtknob
pull back passenger footwell carpet
then sound deadening back
then look up and a grommet where rear wash wipe goes through
poke screwdriver thru it and then get cable thru
Posted: Thu Feb 15, 2007 10:38 pm
by Pedro_Hilario
bobtknob wrote:pull back passenger footwell carpet
then sound deadening back
then look up and a grommet where rear wash wipe goes through
poke screwdriver thru it and then get cable thru
Just like he said
I have a pic of that, if you require.
But, you have two 15 inch subs and dont know where to get the power from?!
Posted: Thu Feb 15, 2007 10:55 pm
by ModifiedMadness
Wouldn't 0 guage be better? I'm only running one 12 and am using 0 guage.
DONE IT!!!
Posted: Mon Feb 19, 2007 12:31 pm
by doublefifteensmk4
finally done cheers for the advise, done my parcel shelf as well jus about to wire that up.....fifteens are kickin arse!!!!!once again!!! WOOOOOOOOOOO im happy i got em back