UK-POLOS.NET - THE VW Polo Forum

is it possable to fit wheels with an offset of 52 with 25mm adaptors to my 9N??


by my calculations there will only be 8mm furthur out than standard wheels and therfore possable and acceptable or could maybe use 20mm or 15mm adaptors to bring the offset back close to the standard one , but im no expert so could be way off

that would be a dead on offset mate.

the 52 ET with the 25mm adaptors you mean?. wouldnt cause any problem with scrubbing or mess my bearings up long term ?

as long as the adaptors are good quality you should be fine, it's just an extension of the wheel in that case, and the loads should be similar to a normal ET35 offset, it's not as if you're going to ET zero or anything.