Page 1 of 1

6n2 Inside door peeling + Airbag light

Posted: Mon Aug 06, 2007 4:16 pm
by hotboy836
Hey guys firstly i wanna introduce myself, im now the proud owner of a 51 plate 6n2 freshly bought second hand with only 2 previous owners. 3 door

The car is brilliant its been driving fine for a week now but the AirBsag light for no reason has come on and i cant figure out for the life of me how to turn it off or reset it or nething.

any help would be much appreciated?


The door handles inside are peeling is there a way to replace them and if so where from?


much thanks.

Re: 6n2 Inside door peeling + Airbag light

Posted: Mon Aug 06, 2007 4:47 pm
by h4r1s
hotboy836 wrote: The door handles inside are peeling is there a way to replace them and if so where from?
Welcome to the site 8), common problem that is on mk5 polos, simple fix though the plastic trim is only a couple of quid from dealers

hope that helps, Haris

Posted: Mon Aug 06, 2007 5:03 pm
by hotboy836
im so new, excuse my stupidity, could you tell me where the nearest dealers are in london? the best i saw was near the m25 but its something like 60 miles from me, which for couple quid is a trek lol.



as for the airbag thing any help? is there like a fuse i could take out sort of like the ecu reset.

Posted: Mon Aug 06, 2007 5:12 pm
by PD
hotboy836 wrote:im so new, excuse my stupidity, could you tell me where the nearest dealers are in london? the best i saw was near the m25 but its something like 60 miles from me, which for couple quid is a trek lol.



as for the airbag thing any help? is there like a fuse i could take out sort of like the ecu reset.
you could try taking the negative off the battery and leave it for an hour that apperntly will reset the ecu.
One of my mates solved his airbag problems by just pushing all the cables connections under the front seats togethor a bit more. Not sure if it would work for you.

Re: 6n2 Inside door peeling + Airbag light

Posted: Sat Sep 01, 2007 12:40 am
by yumzone
hotboy836 wrote: freshly bought second hand
If you brought from a dealer you can get these jobs repaired and replaced free. I did :lol:

Posted: Sat Sep 01, 2007 6:27 am
by hotboy836
yea i know but every time its repaired sonethin else goes wrong and i get back the same problem so a few days ago i said sod it and got my refund.

not worth the hassle.


my dilema now is polo or golf.

Posted: Sat Sep 01, 2007 8:32 am
by yumzone
hotboy836 wrote:

my dilema now is polo or golf.
i had a golf TDI before my polo and I can say honestly say I wish I had kept it. Golfs are solid, Polos are fragile :? IMO

Re: 6n2 Inside door peeling + Airbag light

Posted: Thu Jan 13, 2011 9:48 pm
by np1974np
there are 4 possible; 2 frontbag & 2 seats. Most likely problem is the seats ( as the front are less susciptable) - wiring harhness getting strangled/ stretched by moving the seats forward & backwards. At the floor pan; LHS of drivers seat & RHS of passangers seat, there is plug & socket that leads to seatbelt bucckle. There is no easy cure, but to check continuity of wires; one or more wires has gone open circuit. I have 6n2 TDI that has similar fate.
if you go to vw dealers armed with your VIN nomber, and ask to show you wiring harness BOLD is for your vehicle.

model -PO; year - 2001; mg- 9; sg- 71; illustration - 972 25.

Checking, tracing the open circuit is not for DIY. Any one of the four sensor comes up as a single fault.
If someone has a wiring diagram for seat belt/ air bag how the individual wires are run would be a great help.

Good luck
regards np1974np

Re: 6n2 Inside door peeling + Airbag light

Posted: Fri Jan 14, 2011 10:39 am
by 6N2 GTI 00
Check the dates mate the last post was dated 1st September 2007, chances are the problem has been sold (probably the car too)

All threads are in date order so just make sure you check the dates out first :)