Page 1 of 1
Will PCD 100, ET 49 fit my 1998 Polo?
Posted: Mon Jan 28, 2008 9:09 am
by Bridiemcrae
Good morning,
I have found a set of alloys which are off a corsa, the ET is 49 but I don't know if these would fit my 1998 polo?
Can someone please confirm if these would fit thanks?!
Thanks in advance, Alan.
Posted: Mon Jan 28, 2008 12:50 pm
by polo gangsta
think they should mate, because think vauxhall and vw have same pcd but just to check, ask him if its 4 x 100 because thats what yours will be
Posted: Mon Jan 28, 2008 1:04 pm
by R1CH
check the centre bore too,,,if its too big then youll need spigot rings if its too small then they wont go on.
Posted: Mon Jan 28, 2008 1:24 pm
by NOZ
Not sure how the ET would effect the car although I do know 35-38 is just a recommendation which no one listens to anyway. The centrebore needs to be 57.1 to fit dubs, if not then rings are necessary.
Posted: Mon Jan 28, 2008 1:50 pm
by Mk4 Polo MPI
mate just had confirmation these should go straight on!!
Posted: Mon Jan 28, 2008 8:51 pm
by bstardchild
Mk4 Polo MPI wrote:mate just had confirmation these should go straight on!!
You have corsa wheels fitted to yours or know someone who has?
Posted: Mon Jan 28, 2008 8:58 pm
by bstardchild
NOZ wrote:Not sure how the ET would effect the car although I do know 35-38 is just a recommendation which no one listens to anyway. The centrebore needs to be 57.1 to fit dubs, if not then rings are necessary.
The ET is very important and people should bear it in mind when considering wheels
Centre bore is also important but spigot rings will only take up clearance and will not compensate for a centrebore which is too small
ie if vauxhall centrebore is 55 they won't fit without some machining work
I wrote something on ET's and wheels fitting a while back I'll see if I can find it
Posted: Mon Jan 28, 2008 9:09 pm
by bstardchild
Posted: Mon Jan 28, 2008 11:21 pm
by bstardchild