Page 1 of 1
urgent help required lowering
Posted: Tue Jul 01, 2008 9:32 pm
by loud
trying to lower the front of my car, passenger side went fine but drivers side is being a ****
it wont drop far enough to get the strut out, driveshaft seems to be stopping it dropping...arb is disconnected
any ideas?
Posted: Tue Jul 01, 2008 11:00 pm
by panda
dude,
you need to remove the driveshaft, gearbox end, that'll give you enough room to remove the strut.
Posted: Tue Jul 01, 2008 11:43 pm
by loud
well we couldn't get the ball joint to split but ended up disconnecting some various other bits and managing to get it in with the springs under full compression...what a bloody job!
Posted: Wed Jul 02, 2008 12:10 am
by panda
its not hard tbh, just the drivers side you need to remove the driveshaft from the gearbox side.
Posted: Wed Jul 02, 2008 9:14 am
by loud
we didn't remove the driveshaft, we did it a very unorthodox way
