Page 1 of 1
will a seat leon cupra splitter fit my 2000 6n2
Posted: Tue Aug 19, 2008 12:28 am
by rick
as above
cheers
Posted: Tue Aug 19, 2008 2:43 pm
by 3LL1077
Yea, i have one fitted to mine.
You will need to take your bumper off and trim the middle bits of the splitter off off, then position it in the center, self tap screw/bolt it down the trim the edges off where the wheel arch is.
I have mine attached the original splitter
Posted: Tue Aug 19, 2008 7:00 pm
by xcore
wouldnt it be easier to unclip the original splitter?
Im thinking about putting one on mine also when i have the cash
Posted: Tue Aug 19, 2008 7:09 pm
by CraigMK4
pics Elliot?
Posted: Tue Aug 19, 2008 7:11 pm
by 3LL1077
Take the original splitter off and your left with the bit of the bumper where a standard or gti splitter clips into.
See:
Would look a bit gash without an original splitter of a GTi splitter, plus where on earth would you attach it without cable ties?
This is with the original splitter:
Posted: Tue Aug 19, 2008 7:13 pm
by CraigMK4
can't see it. Take a close up
Posted: Tue Aug 19, 2008 7:15 pm
by 3LL1077
How can you not see
Close enough?
Posted: Tue Aug 19, 2008 7:17 pm
by CraigMK4
I wasn't being funny mate, i seriously can't see it because of my monitor, the contrast on it is terrible. Thanks for the close up, and yes, i can see it now
Posted: Tue Aug 19, 2008 7:19 pm
by 3LL1077
I'm gonna have to find another splitter now, they are getting common on Polos now
Posted: Wed Aug 20, 2008 6:37 pm
by xcore
^^ should sell it to me :p
Posted: Wed Aug 20, 2008 10:51 pm
by 3LL1077
Should think of something original like me
Posted: Thu Aug 21, 2008 12:24 pm
by xcore
hmm i got an old seat ibiza splitter somewere, it could work....