Page 1 of 1
Fitting Milltek turbo back
Posted: Wed Mar 04, 2009 3:18 pm
by loud
I've fitted plenty of exhausts on older cars but never a turbo back system on a modern car, can anyone fill me in on the details of fitting the sensors and if there are any gaskets there which should be replaced?
Re: Fitting Milltek turbo back
Posted: Wed Mar 04, 2009 4:30 pm
by whitegtipolo
dont snap a bolt in your turbo like the garage did on mine lube it overnight then take it slow , if it feels tight warm it up but not too much or it will snap, it helps to wind it back on then off etc etc to free it off!!
