Page 1 of 1
How to change engine oil (6n2)
Posted: Tue Jul 21, 2009 11:16 pm
by revolutionrock
How to change engine oil
A small guide, for those who do not know...
http://18-revolutionrock.50webs.com/polo.htm
Going to make guides about how to change oil sump seal and selector shaft oil seal
/Johan
Re: How to change engine oil (6n2)
Posted: Tue Aug 11, 2009 10:31 pm
by Bepe
your guide to change engine oil is wrong
Dont start your car, before changing oil, let the car cool down not complelty cool, give it 10minutes or so, and all the oil from the top of the block will drain into the sump(you will be draining this) and the oil wont be HOT! and your supposed to change the sump plug+washer too.
Re: How to change engine oil (6n2)
Posted: Wed Aug 12, 2009 5:15 pm
by revolutionrock
Bepe wrote:your guide to change engine oil is wrong
Dont start your car, before changing oil, let the car cool down not complelty cool, give it 10minutes or so, and all the oil from the top of the block will drain into the sump(you will be draining this) and the oil wont be HOT! and your supposed to change the sump plug+washer too.
There is nothing wrong to have the engine hot!
no need to change oil plug if it is good, washer should be change...
Re: How to change engine oil (6n2)
Posted: Fri Feb 08, 2019 11:50 am
by Feeblington
My sump bolt wont budge
i jacked rear of car up and removed filter. Could only get about a litre of oil out.
Fail!
Re: How to change engine oil (6n2)
Posted: Fri Feb 08, 2019 12:56 pm
by alexperkins
Best to use a suction device down the dipstick in that case then