Page 1 of 1
Spraying Wheel Trims?
Posted: Mon Nov 16, 2009 1:34 am
by 5509433
As im bored and for a temporary cheap alternative. what would your opinion on spray wheel trims be?
Also, are these all i would need to complete the job?
http://www.halfords.com/webapp/wcs/stor ... yId_165495
http://www.halfords.com/webapp/wcs/stor ... yId_165495
http://www.halfords.com/webapp/wcs/stor ... yId_165495
Done a quick PS of my car..
Re: Spraying Wheel Trims?
Posted: Mon Nov 16, 2009 7:54 am
by Gary Gee
yea and maybe a little sand paper but if its only temp i woudlnt bother with it... all i did with my wheels was little primer then painted them .. didnt car about laquer ... its not going to be for a long time anyway..
Re: Spraying Wheel Trims?
Posted: Mon Nov 16, 2009 12:22 pm
by 5509433
Well, by temporary i ment when i have enough money for alloys. lol
Which will be quite a long time lol. What grit sand paper should i use?
Re: Spraying Wheel Trims?
Posted: Mon Nov 16, 2009 12:30 pm
by Gary Gee
5509433 wrote:Well, by temporary i ment when i have enough money for alloys. lol
Which will be quite a long time lol. What grit sand paper should i use?
fine... or it will make the trim rough... and s**t....
Re: Spraying Wheel Trims?
Posted: Wed Nov 18, 2009 12:29 pm
by Tim_GTi
they do a pack of a variety of sand paper grades. I'd get that. And use say 600 to key the plastic, then 1200 wet inbetween coats.