Page 1 of 1
Milltek exhaust fitting
Posted: Mon Dec 07, 2009 7:18 pm
by m4tty
I fitted a Milltek (non res, turbo back) to my GTi today, which went fine until i fitted the back box....for some reason when fitted the tailpipes didn't sit central and sit so far over that its just started to melt the bumper. Has anybody had this problem before and no any solutions?
Thanks in advance
Re: Milltek exhaust fitting
Posted: Tue Dec 08, 2009 11:57 am
by Alex_White_Gti
Sort of yeah.....mine actually sat to high and started to melt the bumper at the top untill i put some form of heat proof fabric there.
My Miltek was one of the so called "new revised" version as well..........not just me then lol
Re: Milltek exhaust fitting
Posted: Tue Dec 08, 2009 1:06 pm
by KennyPOLO_Gti
Melted bumper here too!!! lol
Re: Milltek exhaust fitting
Posted: Tue Dec 08, 2009 8:09 pm
by kc
mine was getting there but a cable tie on the hanger sorted it!
ive actually called milltek about it as mine was the development car and they told me to keep an eye on it to see if it gets any worse...
mine actually hangs too low and rattles against the chassis... anyone have that problem too?! lol
Re: Milltek exhaust fitting
Posted: Tue Dec 08, 2009 9:14 pm
by Jeff GTi
mine was one of the first milltek bunch, fits well, no issues or burning
Re: Milltek exhaust fitting
Posted: Tue Dec 08, 2009 10:36 pm
by Rich_T
no problems here now, had mine fitted originaly at work and it knocked and rattled alot, then had it refited at awesome gti when i had the non resonated section installed, they did adjust it and its perfect now
Re: Milltek exhaust fitting
Posted: Sat Dec 12, 2009 2:39 pm
by m4tty
All sorted now, "adjusted" the holes on the bracket and a few cable ties later and jobs a good 'un!
Re: Milltek exhaust fitting
Posted: Tue Jan 05, 2010 9:38 pm
by LWeatherill
any of you guys have your standard GTI box box for sale?
cheers