UK-POLOS.NET - THE VW Polo Forum

got a sheet of carbon fibre sticker ermm stuff! anyway heres how my vents turned out



before


after

really like the look of that dude! reminds me of the m sport trim you get in the e46 coupe's nice touch!

Dub_Dan wrote:really like the look of that dude! reminds me of the m sport trim you get in the e46 coupe's nice touch!

thanks

Looks excellent!

You planning on doing any more or just leaving it at the vents?

blazeguarder wrote:Looks excellent!

You planning on doing any more or just leaving it at the vents?

not sure yet, gets more difficult with bigger/more complex items lol. i'll have to think about it. open to suggestions though?

hmmm, maybe the centre console as well? Might be a bit too much though, door pulls perhaps?

blazeguarder wrote:hmmm, maybe the centre console as well? Might be a bit too much though, door pulls perhaps?

i had a look at centre console...its huge haha lol, could look good. yeah i might have to have a look at door pull area n see how difficult it is to take apart

Can you send me a link to the carbon sheet you used? Cheers

looks awsome! Linky also needed for this carbon wrap stuff. the quality on that finish doesnt look too tacky either.

both pm'd

how do you get the side vents out ? i tried a flat head screw driver but only one side pops out and i dont wana mark anything up by using any more force lol

matt_123 wrote:how do you get the side vents out ? i tried a flat head screw driver but only one side pops out and i dont wana mark anything up by using any more force lol

take off the panel where the fuses are then just push it from behind!!

looks tidy, good job