UK-POLOS.NET - THE VW Polo Forum

hi all!

just cleaned up the car and noticed the right side foglight moulding is sticking out a bit. the left side is flush with the bumper. the bit sticking out is nearest the centre of the car.

i pushed it, it clicked into place (i hope that was it!) but its still sticking out more than the other side.

can someone please tell me if its busted, if i need to push it harder/further into the bumper or if it sounds broken?

anyone who's fitted these, your help would be much appreciated

thanks!

i just saw there's a torx screw - is that right and if so whereabouts?

hope i haven't busted something by shoving it back in...oh dear

thanks

It just pushes in

Remove it completely and see if the clips are fine

thanks - to get it out do i just pull it or are there clips that might break off?

Just yank it out, i did inside corner first