Page 1 of 1
Lamin X - Any people fit it?
Posted: Sun Jul 10, 2011 11:09 pm
by danmorgan
Ive been told that to fit Lamin-X to the 9n3 headlights its quite tricky and requires specific tools.
Does anyone know of/ or themselves fit Lamin-X near Cardiff, Wales area?
Thanks
Dan
Re: Lamin X - Any people fit it?
Posted: Sun Jul 10, 2011 11:34 pm
by lukey GTI
think window tinting people would do this ...ring around a few of ur local tint shops n ask .... something i mite look at soon
Re: Lamin X - Any people fit it?
Posted: Mon Jul 11, 2011 9:04 am
by matt_123
just need a hair dryer or a heat gun which makes it soft and a acraper type thing to mould it round the headlight and make the Lamin-X stick lol. I tried to lamin X my rear lights all red once upon a time and that I found was hard so didnt attempt it again after wasting it. but Ive done a mates headlights before and they were considerably easier
Re: Lamin X - Any people fit it?
Posted: Tue Jul 12, 2011 10:11 pm
by m4tty1
done my foglights yellow and used a hairdryer , no problem once the laminx is hot
Re: Lamin X - Any people fit it?
Posted: Mon Jul 18, 2011 9:12 pm
by duffman502
Did it myself the first time on my 9n gti headlights made a right hash of it and took it off in a couple of days. Then did it on my 6r polo i removed the headlight and made a template out of a big peice of card. Then cut the lamin-x to the same shape didnt try the hairdryer but would imagine it would help. just take your time and its not too painful.
Re: Lamin X - Any people fit it?
Posted: Mon Jul 18, 2011 11:50 pm
by lukey GTI