Page 1 of 1
Wiring from engine bay to cab
Posted: Thu Jan 17, 2013 5:37 am
by R777PHY
Hi I picked up an led badge from eBay for the front and wanting to control it by a switch in the cab jw if any1 has put subs in or something as I can't seem to find any holes or any easy ways to put the wires into the cab any help would be great thanks
Wiring from engine bay to cab
Posted: Thu Jan 17, 2013 1:07 pm
by benmkiv
Should be a grommet in the passengers footwell usually where subs are run. It will be where the steering rack goes through on left hand drives. Hope this helps.
Re: Wiring from engine bay to cab
Posted: Tue Jan 22, 2013 3:33 am
by R777PHY
cheers thanks i have a rh drive so think its diffrent but had a look cant really see anything
Wiring from engine bay to cab
Posted: Tue Jan 22, 2013 10:38 am
by benmkiv
Haa I know you do but the shells are e same from production of lhd and rhd so they leave the steering rack holes on both sides usually. It will be up behind the firewall and behold the glovebo somewhere with a rubber bung filling the hole.
Re: Wiring from engine bay to cab
Posted: Tue Jan 22, 2013 10:39 am
by alexperkins
He didnt mean he had a left hand drive - he meant the grommet would be where the steering rack
would go through if it was a left hand drive
Re: Wiring from engine bay to cab
Posted: Thu Jan 24, 2013 6:48 am
by R777PHY
Cheers ill have another look at it at the weekend my end is filled with snow can't get anything done