Page 1 of 1
Would these fit?
Posted: Wed Jun 09, 2004 4:00 am
by Tahrey1043
This is in the realm of what-if pipedreams... and larceny.
So, I get to drive the works Astra Estate for a day. It's a total slug, and has no driver feedback whatsoever, but quite comfy and smart. I notice it has reasonable (if hideously dirty) 6-spoke alloys on.
4-stud alloys. 195/55 R15s to be precise.
If I were to borrow them for a day (take ownership of it, drive off and work til lunch, then reunite with the polo at break time, scrub & temporarily swap wheels for a quick photo shoot
), or just pick some similar ones up cheaply somewhere and modify the centre caps, would vaux 15-inch wheels with 195/55 rubber have any chance of fitting? Or just a bit too big, with kooky offsets?
I dunno... they're subtle... but smart in a back-to-basics fashion.
Mk3 hatch btw
Posted: Wed Jun 09, 2004 10:06 am
by Speedlaw
Erm, I think the Vaux centre bore is too narrow. The PCD will be fine (4x100) and the offset will ok (too high, but so what) - but the centre bore...
Think it's 56mm instead of 57,something.
I'll look around.
Posted: Wed Jun 09, 2004 12:51 pm
by 4paws
i think ur right speedlaw
my cousin had to bore out the centre to fit vauxhall alloys to her polo have to say it looks ok though
Posted: Wed Jun 09, 2004 2:29 pm
by Speedlaw
Ah right. Well there you go then.
Posted: Wed Jun 09, 2004 3:02 pm
by Tahrey1043
Don't knacker yourself looking for an answer though, if i was ever to have the opportunity to "borrow" I'd probably bottle it..
(and like i could realistically afford alloys before 2005?)
Following those details though, might try putting my 155/70s on the Astra though
.... it could do with a bit of a gearing reduction. (hey... that could work... it'd be like fitting mine with a 4.47 final instead of the 4.06... muchos acceleratos..)
My hubs are a bit battered anyway, I bet I could squoosh them on. Might be a trouble getting 'em in under the rear arches though. Suspension isnt dropped (so front would be fine) but the rear is saggy.