Page 1 of 1
clutch and selector shaft seal
Posted: Mon Aug 05, 2013 4:55 pm
by rishisisodia
Hi all I have a polo 6n2 1.4 16v (75bhp) x reg. the selector shaft seal needs replacing aswel as the clutch I was going to have a go at doing it but was hoping to get a bit of advice about it first.
Any tips on doing the clutch?
also whats the best way to do the selector shaft seal?
thanks in advance guys
Re: clutch and selector shaft seal
Posted: Mon Aug 05, 2013 9:07 pm
by alexperkins
Your best to do the selector shaft seal with the gearbox off
It needs to be hooked out then driven in with a 17mm deep socket
As for the clutch, the Haynes manual is very helpful for this.
Re: clutch and selector shaft seal
Posted: Tue Aug 06, 2013 12:17 am
by rishisisodia
that's a great help thanks for that. Also could anyone email me pics of the Haynes manual instructions as I don't have a Haynes manual. email is:
[email protected]
Re: clutch and selector shaft seal
Posted: Tue Aug 06, 2013 2:37 pm
by rishisisodia
anyone?
Re: clutch and selector shaft seal
Posted: Tue Aug 06, 2013 2:40 pm
by alexperkins
Re: clutch and selector shaft seal
Posted: Tue Aug 06, 2013 2:58 pm
by rishisisodia
wanted to try and get started this evening and tomorrow, no Haynes will get to me in time that's why im asking for pics
Re: clutch and selector shaft seal
Posted: Tue Aug 06, 2013 3:07 pm
by alexperkins
Halfords stock them on the shelves...
Besides, its not just a set of pics. Its about 3 full chapters to cover driveshafts, gearbox, clutch, engine mounts etc.