Head rebuild done BUT!!
Posted: Fri May 02, 2014 6:07 pm
After taking the mrs new car back to the garage after one day of ownership due to low compression on cylinder 3
They rebuild the head, new guides valves head gasket timing chain kit etc
Iv now got the car back but I still think it idles too low and is a bit rough
Touch wood I haven't had the juddering or eml come on but again I still don't think it's quite right
It idles at around 695rpm is that right? For a 3 pot
It also had the coil pack and plugs done by previous owner just before Xmas
Looking for help on this guys?
They rebuild the head, new guides valves head gasket timing chain kit etc
Iv now got the car back but I still think it idles too low and is a bit rough
Touch wood I haven't had the juddering or eml come on but again I still don't think it's quite right
It idles at around 695rpm is that right? For a 3 pot
It also had the coil pack and plugs done by previous owner just before Xmas
Looking for help on this guys?