Page 1 of 1
New wheel problem on 6n2
Posted: Mon Nov 10, 2014 12:41 pm
by globalomega
So I decided to put new wheels on my polo. Bought 14 inch, 6.5j et 30 alloys. And now when I drive I hear this clicking noise and steering wheel stutters/shakes more. Feels wierd on turning.
Is this matter of wheel balance or is it more serious?
Re: New wheel problem on 6n2
Posted: Mon Nov 10, 2014 1:06 pm
by alexperkins
Are the wheels brand new?
First, jack it up and make sure that the wheel spins freely without noise
Second, check your tyre pressures (30 all round)
Re: New wheel problem on 6n2
Posted: Tue Nov 11, 2014 8:56 am
by globalomega
So turns out my front wheel bolts are coming loose ( All of them ) Just after two day driving. I tightened them again now while wheels are cold.
Re: New wheel problem on 6n2
Posted: Tue Nov 11, 2014 8:57 am
by alexperkins
Have you used a torque wrench?
Re: New wheel problem on 6n2
Posted: Tue Nov 11, 2014 9:00 am
by globalomega
Just Regular wheel wrench that lays in my boot with spare.
Re: New wheel problem on 6n2
Posted: Tue Nov 11, 2014 9:05 am
by alexperkins
I would suggest getting them tightened properly at a garage to ensure they dont come undone again
Its a little concerning all the bolts were loose
Could've had a major accident
Re: New wheel problem on 6n2
Posted: Tue Nov 11, 2014 9:30 am
by globalomega
Yea a bit scary. Anyhow I am going to garage on saturday to get my wheel alignment/balance done. Will get the bolts checked aswell then.