Bi-xenon retrofit: problem with xenon range module
Posted: Tue Jun 23, 2015 7:03 pm
dear readers
i have done a full retrofit of oem bi-xenon with help from iichel.
everthing is wired and works oem like. that is very nice of course.
now, the last problem is the xenon range module. it is 6R0 907 357 module.
many error codes but the most important:
- module coded incorrectly
- no end of line programming
if the errors are cleared, headlights do a down-up so wiring is ok and headlights are ok.
the problem is that i cannot code it.
it simply rejects code with an error 22: conditions not met or request sequence error
current coding is for T5 and new code should be 01 8A 00 00 01 00 00 00:
- chassis polo 6R
- rain light sensor installed
- start/stop
- twist link axis
- info via sensor and not via CAN
but coding is not accepted.
it is a used module but i can still define workshop code etc. 12345 123 12345 or my garage codes both dont work
it is vcds 12.12.0
anyone any ideas on how to code it?
i have done a full retrofit of oem bi-xenon with help from iichel.
everthing is wired and works oem like. that is very nice of course.
now, the last problem is the xenon range module. it is 6R0 907 357 module.
many error codes but the most important:
- module coded incorrectly
- no end of line programming
if the errors are cleared, headlights do a down-up so wiring is ok and headlights are ok.
the problem is that i cannot code it.
it simply rejects code with an error 22: conditions not met or request sequence error
current coding is for T5 and new code should be 01 8A 00 00 01 00 00 00:
- chassis polo 6R
- rain light sensor installed
- start/stop
- twist link axis
- info via sensor and not via CAN
but coding is not accepted.
it is a used module but i can still define workshop code etc. 12345 123 12345 or my garage codes both dont work
it is vcds 12.12.0
anyone any ideas on how to code it?
