Page 1 of 1

Bulbs

Posted: Sun Jun 28, 2015 7:08 pm
by Welshgirlx
What bulbs are the drl? And how easy as they to change :D?

Re: Bulbs

Posted: Sun Jun 28, 2015 7:57 pm
by Doc_House
The DRL's are T20's and takes about 10 - 15 minutes with a bit of care and a torx screw driver (one in the tool kit)

Unhook the trim around the foglight, be gentle as it can be brittle around the tabs... I broke mine the first time around.

Unscrew the fog lamp/ drl unit and disconnect the wires.

Remove the outer DRL lamp and replace, push it in to the holder

Reverse the above to refit and make a cuppa :-)

http://www.horizonleds.co.uk/cree-leds/ ... w-cree-led

Re: Bulbs

Posted: Sun Jun 28, 2015 8:12 pm
by TheFrog
This was one of the first mods I did. The LEDs look waaaay better than the horrible yellow factory bulbs. However, I went for the 60W version, as these seem to have about the same brightness as the stock bulbs. I've run them for 6 months now and never been flashed by oncoming motorists.

Re: Bulbs

Posted: Sun Jun 28, 2015 11:09 pm
by Welshgirlx
Doc_House wrote:The DRL's are T20's and takes about 10 - 15 minutes with a bit of care and a torx screw driver (one in the tool kit)

Unhook the trim around the foglight, be gentle as it can be brittle around the tabs... I broke mine the first time around.

Unscrew the fog lamp/ drl unit and disconnect the wires.

Remove the outer DRL lamp and replace, push it in to the holder

Reverse the above to refit and make a cuppa :-)

http://www.horizonleds.co.uk/cree-leds/ ... w-cree-led

Might sound stupid don't laugh but do I have to buy two or is it a set? I would
Of thought a set but it doesn't actually say -.- :(

Re: Bulbs

Posted: Sun Jun 28, 2015 11:11 pm
by Welshgirlx
Also, can you do all this from the outside or do I have to like lean into the engine bay hahaha!
I have a torx ready so:)

Re: Bulbs

Posted: Wed Jul 01, 2015 5:56 pm
by Doc_House
you need a pair of led's and it's all done from the front without getting under the bonnet