Probably the Worlds greatest Polo resource
https://www.uk-polos.net/
kinda new to wiring, only hardwired a dashcam so far, so I'm pretty stuck what to do with itiichel wrote: Tue Feb 20, 2018 1:17 pm excuse my potential rude remark, but there are other users apart from ciclo in this forum that are capable of helping you out.
pin 4 of the 38-pin connector to the ABS unit goes to pin 4 of the 6-pin connector of the push button.
pin 5 of the 6-pin connector of the push button goes to a +15 (ignition switched 12V, pin 35 blue/black wire of the ABS connector)
pin 6 of the 6-pin connector of the push button goes to a ground point, i.e. connect it to the dash cross member
pin 3 of the 6-pin connector of the push button goes to the button illumination signal (i.e. grey/blue wire in the T28 pin connector of the door wiring loom)
This wiring I described is very useful if you want to retrofit TPMS buttonchrisgrogan wrote: Thu May 07, 2020 5:23 pm Yeah,it is what has helped me so far tbh, but isn't that for if you've bought the K418 control unit?
The only thing I could find was actually post from youkinda new to wiring, only hardwired a dashcam so far, so I'm pretty stuck what to do with itiichel wrote: Tue Feb 20, 2018 1:17 pm excuse my potential rude remark, but there are other users apart from ciclo in this forum that are capable of helping you out.
pin 4 of the 38-pin connector to the ABS unit goes to pin 4 of the 6-pin connector of the push button.
pin 5 of the 6-pin connector of the push button goes to a +15 (ignition switched 12V, pin 35 blue/black wire of the ABS connector)
pin 6 of the 6-pin connector of the push button goes to a ground point, i.e. connect it to the dash cross member
pin 3 of the 6-pin connector of the push button goes to the button illumination signal (i.e. grey/blue wire in the T28 pin connector of the door wiring loom)
Oh that's absolutely beautiful, a whole new postiichel wrote: Thu May 07, 2020 6:19 pmThis wiring I described is very useful if you want to retrofit TPMS buttonchrisgrogan wrote: Thu May 07, 2020 5:23 pm Yeah,it is what has helped me so far tbh, but isn't that for if you've bought the K418 control unit?
The only thing I could find was actually post from youkinda new to wiring, only hardwired a dashcam so far, so I'm pretty stuck what to do with itiichel wrote: Tue Feb 20, 2018 1:17 pm excuse my potential rude remark, but there are other users apart from ciclo in this forum that are capable of helping you out.
pin 4 of the 38-pin connector to the ABS unit goes to pin 4 of the 6-pin connector of the push button.
pin 5 of the 6-pin connector of the push button goes to a +15 (ignition switched 12V, pin 35 blue/black wire of the ABS connector)
pin 6 of the 6-pin connector of the push button goes to a ground point, i.e. connect it to the dash cross member
pin 3 of the 6-pin connector of the push button goes to the button illumination signal (i.e. grey/blue wire in the T28 pin connector of the door wiring loom)
For folding mirrors: viewtopic.php?f=56&t=58703&start=330#p481352
. Thank you, I didn't see this one.