UK-POLOS.NET - THE VW Polo Forum

Why complicate the things? clean the rod, put few turns of cloth tape to prevent the zip tie from sliding. remove the plastic clip in for the gaiter that goes into the oem knob. If you want it fancy you could make a groove in the rod for the zip tie using a dremel. Or cut threads into the new shift ...

like any jdm car driver

Hi, I had a similar issue on my 6r. Wiper were to slow. You greasing the linkage joints wont help. You need to disassemble it, and where the spindle ( part that has thread to attach the wiper arm) you will have to remove the c-clips, and push it out. There is a bronze bushing and it gets rusted. I'd...

https://www.kolhosniki.ru/elsaonline

there you can find free manual, with torque specs

buy a brand new nipple Spray the area with wd, let is sit Heat it up with a blow torch, even a heat gun will work. While its hot spray it again with wd-40 or some similar product. Use locking pliers, and lock the on to the nipple and unbolt. If its at some point feels stiff, screw it a bit in, than ...

replace its cheap and easy

try maybe ignition, pedal to the floor for 20s, release turn ignition off. then turn on the car.

good luck, hope you have fun with the new aircraft!

Thanks amer6r, I’ve got the cap off in one piece but cannot extract the filter as there is a metal pipe running above which I need to see if I can remove, two cross head fixings on a manifold type on the right, not very accessible at all and a clamp fitting on the left. Looking through the Elsa, th...

So I acquired a tool which is basically like a spanner end with a square drive for the ratchet. Still cannot get the ratchet bar straight down or anywhere near straight so put on the swivel joint and managed to get some purchase on it. Didn't budge but did crack around the base of the hex on the to...

Casbantam wrote: ↑Fri May 03, 2024 9:13 pm Anyone know if there is a kit to stop pads rattling? Or is it a case of changing the pads?

Cheers

rear ones with metal shims

it supports, i have 087 and cornering lights

Hi, A few months ago, the battery drained on my Polo 6R and was dead, I also found out that the key did not work in the door as it had been replaced by a previous owner. Because of this, i tried to open the door with one of those inflation bags to reach in with a wire and open the handle (i know it...

If you are tight with money and cant afford some repairs, at least wrap the cv joint boot in plastic bag, and duck tape it. It will help, to save your cv joint from getting crap in it and destroying it. The booth it self, some grease, clips and can of brake cleaner is not expensive. go with what 222...

fix all the issue as soon as possible. Every one of them can leave you stranded ( except for the shock and washer pump) Bushing for safety reasons