UK-POLOS.NET - THE VW Polo Forum

iichel wrote: Tue Oct 03, 2023 3:37 pm Any other error codes besides the one p0106 and p0236? Both are marked as static/active?

I’ve just got a normal obd scanner, only showing those two codes. Will get it scanned with vcds hopefully tomorrow and see if anything else is appearing

iichel wrote: Tue Oct 03, 2023 3:22 pm Did you use a genuine vw sensor or some aftermarket?

It was one from gsf. Bosch

I'd start with changing MAP sensor


I’ve changed the sensor and cleared the codes and car seems to drive fine, full power and blow off valve working as should and opening.
However when I turn the car off and on again then the BOV doesnt work and has reduced power. I plug in the obd scanner and ...

I'm not super familiar with these engines, but since the turbocharger sits at the front, I'm guessing the intake manifold is at the rear.
I can only go on the pictures on the web for this.

you can see the sensor here:

https://ik.imagekit.io/kleingunnewiek/gunnewiek/tr:n-share/43bc568e-fc48 ...

Engine bag. Where and how do I get to map sensor to change it?
I was told by RTMG who mapped the car to use this sensor, 038906051C? Would you agree?

iichel wrote: Tue Oct 03, 2023 7:44 am I believe it's the 03G906051M

number 2

How do I get to the sensor to change it?

Could anyone tell me the part number to the map sensor.
I am getting the fault codes:
P0106 - absolute manifold
Was told to change this map sensor
Where is the map sensor located also?

I also have code P0236 - Turbocharger Supercharger boost sensor A Circuit Range / Performance. How can I fix this ...

Hi,

I just had my car scanned and have the following codes:

P010600 - Manifold Abs. pressure or bar. pressure - range/perfomance
STATE:active/Static
System: 01 Engine Electronics

P1853 - databus drivetrain: Implausible Message from ABS Control module
System: 02 Transmission Electronics ...

Hi,

My car is barely driving with the spanner appearing by the gears on the dashboard. It’s been at a garage for 3 weeks with them saying it was the mechatronics unit. They changed this and changed the gearbox 3 times as well as changing any seals. This didn’t fix the issue as then they had the ...

wert90 wrote: Sun Oct 03, 2021 10:41 am Did you finally made that conversion? I am also looking for this one on my 2011 GTI and haven't find anyone here with specific pictures.
Many have made it with a standard 6R so I am not sure if the washer headlights holes fit.

Naa I wasn’t able to get the bumper. I’m still looking aswell

Hi guys,

I made a previous post about my vw polo gti 6r asking if a 6c gti bumper would be a straight swap. I have received these answers as it is. I’ve finally been able to locate a 6c bumper and wanted to know if this would be fine to fit onto my 6r gti??Pictures are to follow of my car and the ...

Thanks for the information! Does anyone know where I can purchase the 6C GTI Bumper from (UK)?

iichel wrote: Mon Jun 08, 2020 3:48 pm It's a straight swap

I’ve had a couple people tell me that the wings and headlights needed to be changed? Do you know anywhere that I can purchase the bumper? Thanks mate!

Hi I would like to know how to covert my front end of the polo GTI 6r 1.4 to the 6c GTI bumper. Is it a straight swap or do the wings and headlight need to be changed as well?
Thanks!