need a bit of help. i'm in a spot of bother lol

rishisisodia · Post by **rishisisodia** » Fri Jan 13, 2006 1:00 pm

there's a few things i wanna knw.
1st) is how 2 take the glovebox out.
2nd) how 2 do the wiring for components if i am amping them.
any help will be most usefull thanks guys n galls x

Bran · Post by **Bran** » Fri Jan 13, 2006 2:57 pm

http://www.tigerstyle.co.uk/poloforum/v ... php?t=5097

rishisisodia · Post by **rishisisodia** » Fri Jan 13, 2006 5:14 pm

lol thanks m8. erm the bit i was after was how 2 get the wires in2 the door x

david burton · Post by **david burton** » Fri Jan 13, 2006 5:54 pm

Drill holes

that's what I did, I drilled a small hole in the A pillar below the main wiring plug, then zip tied the wires to the rubber tube running to the door and then cut a small hole in the rubber tube where it enters the door.

You could (possibly) drill out a part of the big connector plug thing and feed the wires through there. Depends if you have any space free in the connector block.

The connector will twist off - you'll need some big grips to take it off tho!

Bran · Post by **Bran** » Fri Jan 13, 2006 5:56 pm

http://www.tigerstyle.co.uk/poloforum/v ... .php?t=655

this is a good post for door components

rishisisodia · Post by **rishisisodia** » Fri Jan 13, 2006 10:35 pm

awww wicked. u guys are gangsta's! lol thnks ever so much. after my exams i'l do it all n take pix n show u. thanx again
rishi