Where to get BMC CDA

loud · Post by **loud** » Thu Jun 29, 2006 9:12 am

does anyone know where the cheapest place to get a BMC CDA for a 100bhp valver is?

neilw · Post by **neilw** » Thu Jun 29, 2006 10:49 am

Try 2modified through club polo. Neil

Petrified · Post by **Petrified** » Thu Jun 29, 2006 1:18 pm

this'll fit

http://forums.clublupo.co.uk/index.php?showtopic=21630

loud · Post by **loud** » Thu Jun 29, 2006 2:04 pm

interesting...

will it have the right fitments for the cold air feed though, the 16v polo requires a join that the 8v polo doesnt, dont have a clue about the lupos though

Petrified · Post by **Petrified** » Thu Jun 29, 2006 3:48 pm

I beleive you make your own cold air feed. the bmc comes with a flexible pipe around 3' long which should fit on to your existing air feed, but to get the most out of it I would remove the existing one and make your own. as far as I know the polo and lupo are very similar. at least mine were! and take the cold air feed from the driver side wing. it's not that great imo.

loud · Post by **loud** » Thu Jun 29, 2006 4:41 pm

the bmc comes with aluminium ducting to be used for the cold air feed

loud · Post by **loud** » Thu Jun 29, 2006 4:44 pm

i asked 2modified why the 16v ones are more expensive than the 8v, this is the reason...

The basic kit is around Â£140 which comes with the box and a cold air pipe

the Polo 16v also comes with a Silicone bend to attach to the Inlet and a breather filter