WIRING A SUB

jason11 · Post by **jason11** » Wed Oct 11, 2006 12:32 pm

wats the best way of wiring a sub up in a mark 4 polo ??

HELP :)

willriseley · Post by **willriseley** » Fri Nov 03, 2006 9:58 pm

RIGHT!
nice big power cable from the battery with a fuse down the passenger side of the car to the boot.

rca leads down the drivers side and into the boot

remote lead down the middle and into the boot

if you keep the leads apart it helps to stop the inteference

a decent size earth lead from the boot floor or sumwhere there

tuck the wires away so you cant see them and there you go

try and keep the power,rca and remote leads away from each other as much as possible to avoid poor signal

ModifiedMadness · Post by **ModifiedMadness** » Fri Nov 03, 2006 10:24 pm

You can run the RCA's and Remote together if you like, some RCA's come with a cable inbetween them that can be used as a remote

I should imagine a 4guage kit would do the job.

bobtknob · Post by **bobtknob** » Sat Dec 09, 2006 12:08 am

when wiring in the power cale did you guys go through the bulkhead or what?

polo power · Post by **polo power** » Sat Dec 09, 2006 11:16 am

yes there are a few rubber gromits in the bulkhead, which you van run your cable through.

samil87 · Post by **samil87** » Sat Dec 09, 2006 1:12 pm

where wud u suggest the best place to ground the amp?

paulzpolo · Post by **paulzpolo** » Fri Dec 15, 2006 9:01 pm

willriseley, u wont notice any interference,if u run the cables rca and remote,
only if your after a high sound qualitiy,but nothing you will notice....