induction kit for an spi

neb · Post by **neb** » Thu Feb 08, 2007 8:24 pm

hi, looking for an induction kit for a single point injection 6N, i see K&N sell one for the 1.6 spi 8v, so will it fit a 1.0l spi 8v? i presume they run the same size carb?

dragon_green · Post by **dragon_green** » Thu Feb 08, 2007 9:18 pm

uhm, SPI (single point Injection), carbs..... ? I think you must be talking about the throttle body.

ETKA only lists one same injection unit (SPI) for 1.05 to 1.6 engines, codes ADX, AEA, AEV.

There are 2 versions of the ''1.0'' engine. The early one, which is 1.05L (45bhp i think) and the later 0.999L (50bhp).

Which engine code is yours?

bflower59947 · Post by **bflower59947** » Thu Feb 08, 2007 9:19 pm

hey dude i just bought the 8v spi k and n for my 6n and they said on ebay where i bought it that it fits the 1.0L so you should be ok but double check first

neb · Post by **neb** » Thu Feb 08, 2007 9:33 pm

mine is a single point injection 4 cylinder 1043cc, iron block so i think its the older 45bhp, ive already bought a k&n induction kit (57-0193-1) for the mpi which doesnt fit, too small

(now in for sale section

)

dragon_green · Post by **dragon_green** » Thu Feb 08, 2007 10:49 pm

in that case yes it's the 1.05. there are other companies who make induction its out there too

bflower59947 · Post by **bflower59947** » Sat Feb 10, 2007 11:04 am

sorry dude i missed part of my post out. i bought the k and n your were talking about for my 1.6 spi and it all fitted the 1.0L hope that helps

neb · Post by **neb** » Sun Feb 11, 2007 11:39 am

thanks for all the info, been looking around, looks like K&N is my best bet, the only other filter i found was from jetex which didnt even have a cold air feed for a similar price as the K&N