about the dials, it is not very hard to fit, but it takes quite some time, because there are sreews everywhere and some of them are quite in odd places, for example, some screws, you cannot untie them with a srew driver cause it does not fit, i had to use some bits from those muli-purpose screwdrives and turn them with a long nose plier.
regarding the rust, i don't know what they did exacly, the only thing that he told me is that he cannot cut the piece and replace with another because of the place where it is. he told me that the paint was removed and the rust was removed with a wire brush, i dont think that that was enough. Then coating it with zebar and even sealer, and spraying over it again!!
i think that this is going to drive me mad
